Samsung Galaxy Core Prime LTE SM-G361F || how to flashing smartphone core with Version: Lollipop 5.1.1 via odin. Because berabagi mistakes we have done as we are negligent and not maintain so we too much download the application so that smartphone ram becomes full and error so the smartphone can bootlop can not live normally and just stop in logo only, but the problem do not worry if there is still way to live again there is no harm in doing flashing on the smartphone, before that we try to see if the smartphone is still detected on the computer if yes then most likely still can live again, do not have a lot of words we go and live we read the flashing guide below this please you guys pay attention step - by step kara if mistake can - smartphone could get worse and can not live anymore.
NOTE !!! : I am not responsible if there is damage at the time of flashing then of that please be careful for his attention thanks.
Samsung Galaxy Core Prime LTE SM-G361F | ||
Driver | Samsung | |
Odin | Odin3 v3.09.rar | |
Mobile | Galaxy Core Prime LTE | - |
Model | SM-G361F | - |
System Version | Lollipop 5.1.1 | - |
Baseband | NEE G361FXXU1APB1 | - |
Firmware | Download | |
Steps of Flash Galaxy Core Prime LTE SM-G361F
- Things that should not be forgotten is Extrack all the files that have been downloaded because it is still in the form of winrar to live extrack all is wrong because klau already in extrack easy to run the application.
- Open Odin and install Samsung Driver on your PC until finished if it can restart your computer.
- Live step Next turn off the Samsung Galaxy Core Prime LTE SM-G361F and turn it back on by pressing the volume down key + home + power simultaneously and wait for it to vibrate into download mode and press the volume up button then it goes into download mode.
- Connect your Samsung Galaxy Core Prime LTE SM-G361F to your PC using the USB cable so it automatically detected ID: COM on Odin turns on the phone and your PC is connected with Odin.
- Lost click PDA / AP on Odin and navigate the file of your firmware extarck result that is formatted xxx.tar.md5 where you put it there you can enter on odin wait until the loading process is complete.
- Live directly click START and wait until the process is complete until there is a reading PASS.
0 comments:
Post a Comment